The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 03-15-2003, 03:25 AM   #1
Daves72'GMC
Registered User
 
Join Date: Mar 2003
Location: Asheville, N.C
Posts: 952
Question restoration ?

I'm having a restoration done on my 72 GMC in June. Should I have them take off the cab or should I have them leave it on? and should I have them replace the calking around the drip rail and where the doors close? Any advice about my restoration would be helpful. Thank you everyone.
Daves72'GMC is offline   Reply With Quote
Old 03-15-2003, 08:18 AM   #2
minibike
Registered User
 
minibike's Avatar
 
Join Date: Jun 2002
Location: Lafayette, LA
Posts: 500
It is all related to how much money you want to spend on it. A frame off is the absolute best way to go, but you get into more money. As for the caulking, it would be a good idea to wire brush it out and replace. I masked off the area with tape and used a brushable seam sealer in these areas. Worked pretty well.
__________________
69 SWB
LT1/4L60E
www.classicplace.com
minibike is offline   Reply With Quote
Old 03-15-2003, 08:59 AM   #3
Seke69
Space Cadet
 
Seke69's Avatar
 
Join Date: Mar 2003
Location: Twin Cities
Posts: 132
here's a link to another thread further down the board <a href="http://67-72chevytrucks.com/vboard/showthread.php3?threadid=44523">Seam sealer</a> (hopefully I have my code right). they seem to suggest replacing it, I'll probably remove the bulk of it with a screwdriver, then clean it up with a rotary tool/and small wire wheel. but I'll wait for the weather to straighten up so I can prime it...

I hope the link works for you, other wise look back about a page and half. as far as an opinion on frame off or not, that completely up to you, it's more expensive, but more valuable. and takes longer, but usually lasts longer. that's just my opinion...
Seke69 is offline   Reply With Quote
Old 03-15-2003, 09:07 AM   #4
Seke69
Space Cadet
 
Seke69's Avatar
 
Join Date: Mar 2003
Location: Twin Cities
Posts: 132
Oops! I'll try again.
seam sealer
Seke69 is offline   Reply With Quote
Old 03-15-2003, 11:53 AM   #5
ChevLoRay
Old Skool Club
 
ChevLoRay's Avatar
 
Join Date: Jun 2001
Location: Benton, AR "The Heart of Arkansas"
Posts: 10,880
What are you calling "restoration"?

When you ask about whether or not to remove the cab, and what to do about the drip rail sealing compound, are you sure you are doing a restoration? Or, are you just getting it "cleaned up and detailed, with a paint job?

I see ads that state a given vehicle is "90% restored - just needs paint". What some people refer to as "restored" is not that, at all. I had a nice looking '67 Impala convertible. It had to have some rust repair done around the rear wheel openings. The top was new; the carpet was new. The seat covers were redone. The body was repainted in the original color. It had new tires, and the suspension was "repaired as needed". The engine had over 130K miles, as did the Powerglide. The A/C didn't work, nor did the radio. The car was beautiful to look at, and it showed well, but it was NOT restored. At the time I did it, the market for those cars was almost non-existant.

"You pays yo money, and you takes yo chances", is a common saying. When it comes to restoration, time is money. Read in the various automotive magazines, and you will read about someone's vehicle that had to be rescued from one shop and taken to another so the first shops' work could be re-done and the vehicle finished. Get references about their work. Ask to see some vehicles done by them. Talk to their owners.

Good luck.
__________________
Member Nr. 2770

'96 GMC Sportside; 4.3/SLT - Daily driven....constantly needs washed.

'69 C-10 SWB; 350/TH400 - in limbo

The older I get, the better I was.
ChevLoRay is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:26 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com