|
04-02-2009, 10:43 PM
|
#1 |
|
the pollock
Join Date: May 2008
Location: abilene, texas
Posts: 4,423
|
front hub
ok guys.. i got it off..
which was a PITA! front hubbage wont go back on.. the bottom where the the slip ring is.. flush" with the bottom of the hub assy.. it's all hella lubed up.. but i cant get that lasst little bit back on.. was thinking about hald toquen' the top ball joint nut on.. and driving it around the block.. but not sure of the safety =-) i just need 3/16 of an in at most.. please dear god.. help me cause my hammer isnt =-)
__________________
Jack of ALL trades, Master of none.. (but one... procrastination) Army vet 02-08 RIP El Jay! Miss you brother! http://67-72chevytrucks.com/vboard/s...d.php?t=343538 http://67-72chevytrucks.com/vboard/s...d.php?t=386042 |
|
|
|
04-03-2009, 09:15 AM
|
#2 |
|
Registered User
Join Date: Feb 2000
Location: Modesto, CA
Posts: 1,842
|
Re: front hub
Try and reach around with one hand and push/pull on your axelshaft as you fit the hub into place. Sholud plop into place
  It's early and Friday 
__________________
1972 K5 MPFI454/Sm465/Np205/D60/14FFd/Re-Centerd H1s w/Swamper Iroks 
Last edited by Burt4x4; 04-03-2009 at 09:15 AM. |
|
|
|
|
04-03-2009, 11:13 AM
|
#3 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,722
|
Re: front hub
^^ What he said
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
