![]() |
![]() |
#1 |
Only a long story if I tell it
![]() Join Date: Apr 2009
Location: Atascadero, CA
Posts: 93
|
![]()
I have a 250 and an sm465 that I am putting in my 68 panel. It looks like I'm going to have to cut out the transmission tunnel. Has anyone done this, any tips, and where could I get one that fits?
Thanks! |
![]() |
![]() |
![]() |
#2 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: sm465 in a 68 panel ?
I would grab a factory 4 speed high hump from a truck in the junk yard, and then trace it's pring on the floor, then measure in one inch from that line and cut the hole out. mark and drill the holes and bolt it in with some sealer to seal it up.
|
![]() |
![]() |
![]() |
#3 |
Registered User
![]() Join Date: Dec 2008
Location: K.C. Missouri
Posts: 1,024
|
Re: sm465 in a 68 panel ?
Or try the parts board, there is usually a few on there.
|
![]() |
![]() |
![]() |
#4 |
Only a long story if I tell it
![]() Join Date: Apr 2009
Location: Atascadero, CA
Posts: 93
|
Re: sm465 in a 68 panel ?
Does anyone happen to know what trucks came with an sm465 that I could get one off
|
![]() |
![]() |
![]() |
Bookmarks |
|
|