|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-06-2008, 03:42 AM
|
#1 |
|
I had a V-8
Join Date: May 2003
Location: Phoenix AZ
Posts: 1,116
|
Complete Bracket And Pulley Setup
Complete bracket and pulley setup for a small block with power steering and A/C. Came off of my '72 Suburban. It is getting a Cummins, but I glass beaded all of these and painted with the correct low gloss paint before the final decision on which motor it was getting was made, so they are ready to run. They are in very nice condition--appear to be straight and the bolt holes have no galling around them.
        Now, not having installed the small block, I never mounted these up, so I am assuming it is complete. What is pictured is what I have for it. $175 + ship (Reasonable offers will be considered) Please respond in thread. Thanks!!
__________________
1972 K20 Suburban, 5.9L Cummins, Banks Power Pack, NV4500HD, NP205, H.A.D., D60/14FF ARB Link To Build: HERE. Last edited by mosesburb; 12-20-2008 at 12:56 PM. |
|
|
|
04-20-2009, 11:03 AM
|
#4 |
|
trucks72
Join Date: Jul 2002
Location: Crossville
Posts: 315
|
Re: Complete Bracket And Pulley Setup
I will take those. Sent you a pm
|
|
|
|
|
04-20-2009, 05:55 PM
|
#5 |
|
1972 K20
 Join Date: Apr 2008
Location: Greenfield MN
Posts: 360
|
Re: Complete Bracket And Pulley Setup
Dang too slow... I will take those if trucks72 passes!
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
