How do you tell if it's a 50th? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Dynomutt · 05-16-2009, 11:53 AM

Sorry if this has been covered before, and I'm sure it has. I didn't come up with much in searches.
I'm going to look at a truck that is believed to be a 50th but I don't know how to tell for sure. I do know about the paint but that's it. I also know that the driveline has been replaced in this one.
Anybody got suggestions what to look for?

drivethechevy · 05-16-2009, 12:06 PM

the parchement colored intirior

Dynomutt · 05-16-2009, 12:08 PM

Quote:

Originally Posted by drivethechevy

the parchement colored intirior

I'll look for that. Not sure if the seat in it is original or not.

I also just found in searches that the paint code should read 515 but in another post it says 551. ??????

100%Chevy · 05-16-2009, 09:41 PM

There's some pictures of mine in Picture Trail below.
Shows interior with buddy buckets.Some had the bench seat,but all had the special interior colors of gold and parchment with slightly darker gold dash pad.Also gold carpet.Parchment door panels and armrests on gold doors.

http://www.picturetrail.com/100chevy

Mike.

Bob 68327 · 05-16-2009, 11:02 PM

Quote:

Originally Posted by Dynomutt

I'll look for that. Not sure if the seat in it is original or not.

I also just found in searches that the paint code should read 515 but in another post it says 551. ??????

551 is the paint code . Look for gold dash pad and visors and the parchment door panels as said above . Here are a few pics of mine . Bob

Dynomutt · 05-17-2009, 01:15 AM

Thanks for the info guys.
I did go look at the truck and it was a 50th. Dash was painted black, the dashpad was now black and the seat had been recovered. The SPID was still in tact and the paint code was 551. The truck was real straight and it has VERY little rust. Cab supports had NO rust, inner rockers had NO rust. the driver rocker had a small spot that needed repair (about 3" x 2" area near the front, the pass side floor had one small spot that needed repair (about 2" diameter). Paint is pretty rough (well beyond patina) and there is a little damage on both sides of the bed at the outer edge of the tail lights. The only trim left on the truck was the grill rings but they would need to be replaced. Since I'm not REALLY in the market for another truck, it didn't follow me home. I went to look at it in hopes that I could pick it up, do a little to it and put it on the road until I got through a few other projects. This is NOT that kind of truck IMO. Would definately be an excellent start to a project though. I may still go back to get it but I sure don't need it. I'm just hoping somebody gets it that will do it right.

anson0487 · 05-17-2009, 10:58 AM

I have a truck that is the right color but with rubber floor mat and painted door panels and was a stepside. Is this not a 50th ?
Name: EBAY 308.jpg
Views: 252
Size: 32.7 KB

Name: EBAY 308.jpg
Views: 252
Size: 32.7 KB

Longhorn Man · 05-17-2009, 11:34 AM

we need to see the SPID. If it is, then it is the first 50th stepside i have been made aware of.
Gold dash pad and visors, white door panels, gold and white seat, 551 paint code, and 627 int. code.

**Hart_Rod** · 05-18-2009, 01:12 PM

Anyone got an extra 50th passenger fender??

jay-dawg · 05-18-2009, 01:26 PM

Quote:

Originally Posted by Longhorn Man

we need to see the SPID. If it is, then it is the first 50th stepside i have been made aware of.
Gold dash pad and visors, white door panels, gold and white seat, 551 paint code, and 627 int. code.

X2 for pics. I know some of the guys wanted to do a 50th stepper, me included.

**Hart_Rod** · 05-18-2009, 01:48 PM

Quote:

Originally Posted by Longhorn Man

we need to see the SPID. If it is, then it is the first 50th stepside i have been made aware of.
Gold dash pad and visors, white door panels, gold and white seat, 551 paint code, and 627 int. code.

Mines got the 551 paint code, but the interior code is 625......Is it still a 50th?

Bob 68327 · 05-18-2009, 11:06 PM

Quote:

Originally Posted by Hart_Rod

Mines got the 551 paint code, but the interior code is 625......Is it still a 50th?

yup my interior is 625 also . Yours is a 50th

It should have gold dash pad and visors with parchment door panels . Bob

**Hart_Rod** · 05-18-2009, 11:37 PM

Quote:

Originally Posted by Bob 68327

yup my interior is 625 also . Yours is a 50th

It should have gold dash pad and visors with parchment door panels . Bob

It has both. Now if I could just find a good passenger side fender,

.

R/

Longhorn Man · 05-19-2009, 05:03 PM

I think the 625 verses 627 is the cloth verses vinyl.

stllookn · 05-19-2009, 06:37 PM

'68 vinyl is 626...cloth is 625. I only know this since I have two glove box doors sitting on my office floor...LOL!

05-16-2009, 11:53 AM	#1
Dynomutt Registered User Join Date: Mar 2009 Location: North Texas Posts: 440	How do you tell if it's a 50th? Sorry if this has been covered before, and I'm sure it has. I didn't come up with much in searches. I'm going to look at a truck that is believed to be a 50th but I don't know how to tell for sure. I do know about the paint but that's it. I also know that the driveline has been replaced in this one. Anybody got suggestions what to look for? __________________ MARQ Build Thread http://67-72chevytrucks.com/vboard/s...d.php?t=446194

05-16-2009, 12:06 PM	#2
drivethechevy Registered User Join Date: May 2007 Location: Buffalo MN Posts: 606	Re: How do you tell if it's a 50th? the parchement colored intirior __________________ Trial and Error, its expensive but its a mistake i most likely wont make again 1971 chevy k10 custom deluxe http://67-72chevytrucks.com/vboard/s...d.php?t=341257 1968 chevy k/10 fleet http://67-72chevytrucks.com/vboard/s...d.php?t=334731 1948 desoto custom coupe fluid drive(family heirloom)

05-16-2009, 09:41 PM	#4
100%Chevy Registered User Join Date: Jun 2008 Location: Moss Point,Ms. Posts: 1,439	Re: How do you tell if it's a 50th? There's some pictures of mine in Picture Trail below. Shows interior with buddy buckets.Some had the bench seat,but all had the special interior colors of gold and parchment with slightly darker gold dash pad.Also gold carpet.Parchment door panels and armrests on gold doors. http://www.picturetrail.com/100chevy Mike.

05-17-2009, 01:15 AM	#6
Dynomutt Registered User Join Date: Mar 2009 Location: North Texas Posts: 440	Re: How do you tell if it's a 50th? Thanks for the info guys. I did go look at the truck and it was a 50th. Dash was painted black, the dashpad was now black and the seat had been recovered. The SPID was still in tact and the paint code was 551. The truck was real straight and it has VERY little rust. Cab supports had NO rust, inner rockers had NO rust. the driver rocker had a small spot that needed repair (about 3" x 2" area near the front, the pass side floor had one small spot that needed repair (about 2" diameter). Paint is pretty rough (well beyond patina) and there is a little damage on both sides of the bed at the outer edge of the tail lights. The only trim left on the truck was the grill rings but they would need to be replaced. Since I'm not REALLY in the market for another truck, it didn't follow me home. I went to look at it in hopes that I could pick it up, do a little to it and put it on the road until I got through a few other projects. This is NOT that kind of truck IMO. Would definately be an excellent start to a project though. I may still go back to get it but I sure don't need it. I'm just hoping somebody gets it that will do it right. __________________ MARQ Build Thread http://67-72chevytrucks.com/vboard/s...d.php?t=446194

05-17-2009, 10:58 AM	#7
anson0487 One of these days....... Join Date: Apr 2006 Location: Oklahoma Posts: 102	Re: How do you tell if it's a 50th? I have a truck that is the right color but with rubber floor mat and painted door panels and was a stepside. Is this not a 50th ?

05-17-2009, 11:34 AM	#8
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: How do you tell if it's a 50th? we need to see the SPID. If it is, then it is the first 50th stepside i have been made aware of. Gold dash pad and visors, white door panels, gold and white seat, 551 paint code, and 627 int. code.

05-18-2009, 01:12 PM	#9
Hart_Rod ************* Join Date: Apr 2005 Location: Pensacola, FL Posts: 17,858	Re: How do you tell if it's a 50th? Anyone got an extra 50th passenger fender?? __________________ Rob - https://www.instagram.com/hart_rod_c10 As Iron Sharpens Iron, So One Man Sharpens Another. Proverbs 27:17 FOR SALE: DBW pedal bracket - http://67-72chevytrucks.com/vboard/s...d.php?t=651123 FOR SALE: Hood Brackets http://67-72chevytrucks.com/vboard/s...d.php?t=679945 1987 Silverado SWB - 34.5K original miles http://67-72chevytrucks.com/vboard/s...d.php?t=801834 1969 SuperBurb - http://67-72chevytrucks.com/vboard/s...d.php?t=200387 1968 Farm truck - http://67-72chevytrucks.com/vboard/s...d.php?t=358692 1968 SWB - http://67-72chevytrucks.com/vboard/s...d.php?t=551258 1948 Chevy - http://67-72chevytrucks.com/vboard/s...=122164&page=3

05-19-2009, 05:03 PM	#14
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: How do you tell if it's a 50th? I think the 625 verses 627 is the cloth verses vinyl.

05-19-2009, 06:37 PM	#15
stllookn Saving 1 truck at a time! Join Date: Aug 2001 Location: Kent, WA Posts: 6,465	Re: How do you tell if it's a 50th? '68 vinyl is 626...cloth is 625. I only know this since I have two glove box doors sitting on my office floor...LOL! __________________ '68 C20 Longhorn 50th Anniversary 400/TH400 '68 C20 Longhorn 50th Anniversary 468/TH400w/buckets '72 C20 Halfhorn (Longhorn w/o cab and front clip) '69 Flxible Cruiser (look up ugly in the dictionary) Last edited by stllookn; 05-19-2009 at 06:38 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.