![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jun 2007
Location: South Carolina
Posts: 106
|
What shims with a 4/6 kit
Been wanting to do this ever since I got the truck. Sitting that high with no sway bar makes driving this this thing aggresive is near impossible. The few times I got it side ways with my open rear end it feels like it wants to flip. I made myself a promise that I would stiffen this thing up before putting a posi unit in it. Any ways I'm going to pick up some shims to even this thing out for the ride to the alignment shop (work) Any body know what will get the camber close close? 1.5 springs and spindles. Thanks.
|
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What shims with a 4/6 kit
I always just take a big carpenter's square and put it between the ground ands ide of the tire, then add shims until it sits straight up and down. That will get you very close.
__________________
I'm on the Instagram- @Gearhead_Kevin |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jun 2007
Location: South Carolina
Posts: 106
|
Re: What shims with a 4/6 kit
I was thinking of tHrowing a couple 1/8" in each and going from there. I know this is a popular drop and wondered if anone knew what straightend their truck up. Waiting on fun parts is hard!
|
![]() |
![]() |
![]() |
Bookmarks |
|
|