NEW 350 Hydraulic roller engine.

[crossy]

Another Garage obstacle. This is a complete NEW GM crate 350 Chevy engine.minus intake.One piece seal. Only one dealer had them. Built by GM with all new parts . These are fantastic TBI replacement engines or very torquey street 4 barrel engines. No warranty left because of time lapse. Has been safely stored. Nodular iron crank(stronger than cast), new style LT1 PM rods(very strong),Hyperutectic 9.5 to 1 pistons(with current heads).small ,torque type hydraulic roller cam.about a 50 HP boost over your current TBI engine.This engine will work in any 95 or older pickup and can be equipped with an aluminum 4 barrel manifold.(Edelbrock #2104 and I have one. ). I also have a set of mildly reworked 350 TBI heads that have new 1.94 intake valves and corvette LT1 springs on them. I have a new takeout, Corvette LT1 cam that will kick this up another 25 HP. I saw these engine make 280HP with the cam And head change with stock wimpy TBI on it .If you are not sure whether this will work with your vehicle then email or call and I can tell you. If needed.can be set up to hear run.can be crated & shipped. Engine $1800 FIRM. heads & LT1 cam $495. 856-678-7883 before 9PM EST. . Be VERY specific when Emailing please. all4trux@snip.net . located in so. N.J., I may consider smaller parts on trade. hot rod or musclecar. Thanx , DAVE

[crossy]

someone here on the boards asked me privately how much it was to ship to Louisiana and i don't know what i did with the Email address.. i got several quotes for this that ranged from $235 to 600+ . i'll do it for $300. lemmeknow , DAVE