|
08-13-2009, 11:26 AM
|
#1 |
|
Registered User
Join Date: Apr 2007
Location: Sandpoint, Idaho
Posts: 178
|
Screw size help.
I replaced my motor and transmission (SM465) and am just finishing up. I lost my bag of screws that hold on the inspection plates (?). If I am using the wrong name, it's the two aluminum pieces that screw onto the block and tranny under the flywheel. Does anybody know the screw size for these pieces?
__________________
1969 Chevy K20 Custom Camper 350, 4sp, 33's High on plans, Low on funds |
|
|
|
08-13-2009, 11:53 AM
|
#2 |
|
Restoring it $200 at a time...
Join Date: Aug 2008
Location: NE Kansas
Posts: 887
|
Re: Screw size help.
Pretty sure they're 1/4-20.
__________________
Charter member of the 'Put the dimmer switch back on the damn floor where it belongs' Society '68 5.3L-4 speed LWB C20; grandpa bought it for the farm in '71. Now LS 5.3, rather than 327. DD '09 Pilot Weekender '65 Skylark 300-4V-4 speed Wife's '07 Lexus ES350; 117 actuator motors and I can't see the engine. Son's '04 F250 SuperCab 6.0 |
|
|
|
|
08-13-2009, 07:22 PM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Screw size help.
1/4-20x1/2"
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
08-13-2009, 09:15 PM
|
#4 |
|
Registered User
Join Date: Apr 2007
Location: Sandpoint, Idaho
Posts: 178
|
Re: Screw size help.
Thank you for the replies, I will get those back on and I will almost be ready to start her up for the first time in almost a year.
__________________
1969 Chevy K20 Custom Camper 350, 4sp, 33's High on plans, Low on funds |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
