Tilt column question

[Thealien]

Originally Posted by Hart_Rod

That's probably within tolerance. Is it an aftermarket wheel? Sometimes the adapters aren't that good. Did you try tightening the wheel nut down more? Just some thoughts.

It is a GMC wheel from a later year truck. I used an impact and was afraid to tighten it any more. The nut went on enough that I could put the clip on the end of the shaft. I may just pull it off tommorow and try some never seize or grease on the splines? If its "normal" I will leave it but I am a little anal about things and want it right?!

Mark