|
09-03-2009, 12:28 PM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,393
|
Valve Cover Question
Happy Labor Day early to you all
 Have a question on an early 235, will a 216 valve cover fit a early 235 ? I took mine off and found the bottom of the inside covered with rust from sitting for years. It has the two holes in the center of the cover with the o rings around the studs......Thanks
|
|
|
|
09-03-2009, 01:29 PM
|
#2 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Valve Cover Question
I have a 58 - 235 valve cover on the engine that is going to be scrapped. I can look at it tonite to see if it is clean.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project Last edited by OrrieG; 09-03-2009 at 01:30 PM. |
|
|
|
|
09-03-2009, 01:52 PM
|
#3 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,393
|
Re: Valve Cover Question
Thanks Orrie, Where are you located ? I am in LaGrande aera above Boise.
|
|
|
|
|
09-03-2009, 06:36 PM
|
#4 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Valve Cover Question
In Boise, older neighborhood right below the airport.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
