|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-29-2009, 11:07 AM
|
#1 |
|
Registered User
Join Date: Mar 2009
Location: Austin
Posts: 61
|
Need some quick help! (Head Gasket Question)
Morning all,
Went to put the heads back on the truck today but when I laid the head gasket on the block I noticed I was missing a hole on the rear side. It is the large rectangular one that appears to connect into the water passages. Now, the Felpro gasket numbers are the exact same (8523PT1, referenced as the required gasket by the parts shops for a 454 Chevy) but the old ones appear to have the holes. Were these spots just worn away by the action of the moving water or do I have the wrong gaskets (Which means the PO installed the wrong ones)? o.0 Head has a matching passage so I think it would be safe to assume that water does need to be moving through this area. So confused.... Last edited by cLaWz; 09-29-2009 at 11:42 AM. |
|
|
|
09-29-2009, 11:24 AM
|
#2 |
|
Registered User
Join Date: Mar 2009
Location: Austin
Posts: 61
|
Re: Need some quick help! (Head Gasket Question)
Last edited by cLaWz; 09-29-2009 at 11:38 AM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
