|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-19-2009, 12:51 AM
|
#1 |
|
Registered User
Join Date: Jun 2008
Location: pensacola fl
Posts: 3,072
|
Centering front wheel in well
I have searched on here and seen 3 diff measurements. My truck is all torn apart so I was wondering what the real number of inches forward the x member needs to be? Thanks
__________________
68 BB burb build thread Scott's super slam front/rear http://67-72chevytrucks.com/vboard/s...d.php?t=378084 |
|
|
|
10-19-2009, 10:28 PM
|
#2 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,984
|
Re: Centering front wheel in well
Quote:
You've prob seen 3 diff dimensions because "how much it needs to be" is subjective. Each person possibly started their build @ a different height thus different results. The best way is to measure your ride & decide how much is needed. Without that, 1.5" forward seems to be a consistent dimension that would yield good results.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
|
10-22-2009, 10:18 PM
|
#3 |
|
Texas Big Wig
Join Date: Jan 2007
Location: Mineola, Texas
Posts: 5,620
|
Re: Centering front wheel in well
Like Scoti said, the best way (and the only way to get it just right) is to at least mock up you front clip with the truck at ride height & measure to see how much it needs to move
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
