Shackle flip kit? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Oilbrnr · 11-20-2009, 05:38 PM

No I did not lower my TC. I had to rebuild and lengthen both front and rear drive shafts so I bit the bullet and put the CV on the rear at the same time. ~$750

84 400 · 11-20-2009, 06:23 PM

Quote:

Originally Posted by Oilbrnr

No I did not lower my TC. I had to rebuild and lengthen both front and rear drive shafts so I bit the bullet and put the CV on the rear at the same time. ~$750

Ouch. Yeah a CV is defiantly a good idea ether way. I think my front shaft might need to be lengthen but I am going to wait till i swap in my SM465 Np205 set up.

Thanks for your input on pinon angles gave me a better understanding

Hopefully this helps others wanting to do the flip

11-20-2009, 05:38 PM	#1
Oilbrnr Registered User Join Date: Feb 2009 Location: Scottsdale, AZ Posts: 390	Re: Shackle flip kit? No I did not lower my TC. I had to rebuild and lengthen both front and rear drive shafts so I bit the bullet and put the CV on the rear at the same time. ~$750 __________________ -Don- '66 C10 w/factory A/C '77 Cheyenne K5 350/465/205 '80 Custom Deluxe K20 350/465/205 '04 Denali XL '05 DMax CCLB 4x Have a Hickey Sidewinder Winch and need the owners/install manual? Send me a PM with your email address and I'll forward you a .pdf



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.