Driveshaft question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**pdr510** · 11-22-2009, 03:55 PM

How far should the yoke slide into the tranny when there is no load on the rear suspension? I have a 700r4 with a correct 700r4 yoke.

Tx Firefighter · 11-22-2009, 07:20 PM

My local driveshaft shop told me to always bottom it out then pull it 3/4 inch back out. That is correct for truck at ride height.

11-22-2009, 03:55 PM	#1
pdr510 Junior Member Join Date: Oct 2005 Location: LA Posts: 158	Driveshaft question How far should the yoke slide into the tranny when there is no load on the rear suspension? I have a 700r4 with a correct 700r4 yoke. __________________ 1970 C-10 Fleet Side Gen IV 6.0 with 4L80E

11-22-2009, 07:20 PM	#2
Tx Firefighter Watch out for your cornhole ! Join Date: Jun 2003 Location: Azle, Texas Posts: 14,162	Re: Driveshaft question My local driveshaft shop told me to always bottom it out then pull it 3/4 inch back out. That is correct for truck at ride height. __________________ I'm on the Instagram- @Gearhead_Kevin



Register or Log In To remove these advertisements.