|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-19-2009, 05:34 PM
|
#11 |
|
Registered User
 
Join Date: Jan 2007
Location: Columbus, Ohio
Posts: 4,374
|
Re: 1972 Blazer - 'Bullet' Project
OK - so about 2 hours in the cold garage - I now know that I am horrible at doing the patch panel thing...
My cab mount turned out horrible - wrong angle - huge gap...it is better just to replace the whole thing instead of cutting one down? This crap takes forever...and I haven't even started to think about welding yet...yikes. I did move my keg-o-rater CO2 tank over to the welder but the output on the regulator and input on the welder are different - so I need to improvise something to make it work [a reducer of some sort]. Anybody have any advice? |
|
|
| Bookmarks |
|
|
Threaded Mode