|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-01-2010, 09:48 PM
|
#1 |
|
Registered User
Join Date: Mar 2009
Location: Chatsworth, CA
Posts: 236
|
Newbie Needs Help with Power Steering Conversion
 Does anyone know how to fit the power steering pump to the inline six block? Attached is a picture of the pump and bracket I bought. I know the bracket fits a V8, but not sure about the six. I have plans to do the V8 swap, but it sure would be nice if I could throw on the power steering in the interim. Last edited by dabruce15; 01-01-2010 at 09:49 PM. |
|
|
|
01-02-2010, 03:41 PM
|
#2 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,993
|
Re: Newbie Needs Help with Power Steering Conversion
6 Cyl and V-8 brackets are totally different animals.The 6 cyl brackets are around but more rare than the v-8 ones.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
