Burb stock headliner question

[rsavage]

If someone has a stock factory headliner in their burb with no rear air, could you tell me the approximate length of the final panel up against the rear? It appears to me that it would be a rather short panel compared to the other panels say like 10" as opposed to 23". Need to confirm. Photo would be beautiful if possible. Thanks in advance.

[travlinman]

if u go a cple posts down in the other 68 interior question theres a pic of a headliner w/o air if it helps...
i dont have any of my own to post.

[PortHeadlight]

Look at the photos a couple posts down and you will see that the back panel is bigger than the middle two. I have my headliner out and measured it for you. It's 32 1/8 inches at the centerline, and flares out at the back to 34 inches. I could probably make you a paper template to get the curve you need for the back... and mail it to you.

[rsavage]

Thanks for the info. I bought a used headliner set up and the front panel is about 36" with the rest that were included all 23" except for a longer one with the cutout for an AC unit. Obviously I can't use that one. I have a couple of extra 23" panels, so I may be able to splice one together? I may just take you up on that offer Portheadlight. PM me with the costs and with your paypal email address if you have a paypal account so I can pay you for postage & envelope. Thanks again to you both.

[PortHeadlight]

PM me your address and I'll get it in the mail over the weekend. Easy to do. Nice offer to pay but not necessary. Lots of folks on this board share all kinds of good stuff and it will come back around.

[rsavage]

PortHeadlight,
Thanks much. PM sent. I hope I can assist you in the future.