WIW '66 Chevy 3/4 axle, crossmember, wheels, tires, complete

[GMCMG]

I have a complete setup off my '66 3/4 ton frame I am wanting to sell, and would like to know what is reasonable. I had been looking to sell these as a complete set, but am willing to break it all up (a guy stopped by a while ago wanting to buy rims/tires).
I don't know what the gearing is in the rear end, but would be willing to figure out if that makes a value difference. It is an open rear end. See pics. Thanks for any input. Oh, I haven't cut any brackets off the axle, though I did accidentally cut one of the brake lines when cutting the u-bolts to remove it from the trailing arms (replace 'em anyway...).

[Todd68Chevy]

I do not know if this will help but I had a guy contact me looking for 3/4 ton truck rear ends. He is looking for Eaton H072 rear ends out of 1972 and older trucks. He wants 4.10 thru 5.13 gears and says they need to have a bolt on the drivers side that goes into the housing and pushes against the ring gear? He uses them in pulling trucks and said he is willing to pay up to $100.00 to $150.00 a piece for the rear ends. If you decide to break up the set you might want to check into someone with pulling trucks. This guy is located west of Indianapolis, IN so he might not want to travel that far but you never know. If you want his phone number let me know. Thanks, Todd