Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-01-2010, 02:31 AM | #1 |
Registered User
Join Date: Jun 2009
Location: Olds, Alberta, Canada
Posts: 107
|
Upper/Lower control bushings, 69 C10
Replacing these on my truck, when I torque them up I'm concerned about over tightening. Shop manual says 95ft/lbs upper and 135 ft/lbs lower. I'm unable to turn the shafts on the lower ones, I can with a large wrench on the uppers. Is this normal? All stock replacement parts.
Ron |
04-01-2010, 03:03 AM | #2 |
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: Upper/Lower control bushings, 69 C10
Ron-
You will want to torque the bushings with the arms installed on the truck and at ride height.
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
04-01-2010, 12:00 PM | #3 |
Registered User
Join Date: Jun 2009
Location: Olds, Alberta, Canada
Posts: 107
|
Re: Upper/Lower control bushings, 69 C10
OK will do. I've got an old 69 GMC Chassis manual, following it. The book says to torque them up, but there should be free movement in the shaft. I don't see how there can be, when tight.
Ron |
Bookmarks |
|
|