|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-15-2003, 08:57 AM
|
#1 |
|
Senior Member
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,269
|
Junk yards off I64 in VA???
Am heading east towards Norfork VA this weekend on I 64 from KY. Any decent yards between Richmond and Yorktown. Will be staying in Glouster Pt. Va. for a few days. AND, I promise not to take ALL the good stuff~~~~~~! Huck
|
|
|
|
05-16-2003, 08:13 AM
|
#2 |
|
Senior Member
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,269
|
ttt
|
|
|
|
|
05-16-2003, 11:30 AM
|
#3 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
Not sure about between Richmond and Yorktown, But if you get a chance to go further south there are quite a few on 58 between Chesapeake and Suffolk near the Hampton Roads airport. About 45 minutes from Yorktown, You'd get on 664 south(from 64) then get on 58 west, they are all on the left side.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
