|
04-27-2010, 07:50 PM
|
#1 |
|
Registered User
Join Date: Apr 2010
Location: Peoria, AZ
Posts: 7
|
Introduction!!!
Well I've been getting information from this site for a while now so let me start out by saying thanks to everyone for the help you've already given me. My dad and I are finally kicking it into gear and going to restore my grandpa's truck. (Now Mine... But still his... you know what I mean)
It is a 1973 Chevy  3/4 ton 4WD longbed with a 454 and 700 tranny. I'm going to start a build thread once I get some more time to upload pictures and what not... but until then, here are a few teasers!   If you're wondering about the crazy paint situation going on, that is a result of a couple hour long fight with aircraft stripper. When we were done the word sandblast came to mind. HAHA  Bed off with old wood and slats removed.  We have separation!!  Ironically, my dad and I aren't in any of these pictures... we'll have to stop being so camera shy |
|
|
|
04-27-2010, 09:44 PM
|
#2 |
|
The One And Only !!!
Join Date: Jan 2007
Location: Hole in the woods Florida
Posts: 4,567
|
Re: Introduction!!!
Welcome !
Looks like you have a major project goin on there, It should be a beaut when finished....
__________________
93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz !  The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
