Ideas for installing the side moulding (trim).. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

misternash2 · 04-28-2010, 08:39 PM

very nice pickerup. i'd leave the moulding off also, personally. the fender emblems, too

RandyP · 04-28-2010, 09:15 PM

Look factory you say? Start with fixing the suspension, then the grille and headlamps.

The side mouldings are double back tape, cut to fit, available from lots of sources. The holes you speak of are probably on the bed corners under the tail lights, there are metal corner mouldings that go on there and are held on with clips and nuts. Your fender emblems, double back tape holds them on.

04-28-2010, 08:39 PM	#1
misternash2 Registered User Join Date: Dec 2009 Location: monett, mo Posts: 230	Re: Ideas for installing the side moulding (trim).. very nice pickerup. i'd leave the moulding off also, personally. the fender emblems, too

04-28-2010, 09:15 PM	#2
RandyP Getting Old; Going Broke Join Date: Apr 2010 Location: Owasso OK Posts: 2,764	Re: Ideas for installing the side moulding (trim).. Look factory you say? Start with fixing the suspension, then the grille and headlamps. The side mouldings are double back tape, cut to fit, available from lots of sources. The holes you speak of are probably on the bed corners under the tail lights, there are metal corner mouldings that go on there and are held on with clips and nuts. Your fender emblems, double back tape holds them on. __________________ *Why is every used 350 sbc out of a corvette?* There's only two things that excite a man, expensive toys and real expensive toys. *VEGETARIAN: That's an old Indian word meaning "I don't hunt so good."* When the going gets tough, switch to power tools.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.