|
05-09-2010, 04:03 PM
|
#1 |
|
Junior Member
Join Date: Jun 2001
Location: webster,n.y.,usa
Posts: 127
|
shout out for help
need some help ? i went to look at a 71 or 72 4x4 frame and i have two questions. first did chevy make a 3/4 ton front axle disc brake and open knucles with no lock outs it has a cast piece and not like 73 with the little metal end the whole thing is cast. number two do you think that a complete frame minus motor in need of sandblasting is worth 750.00 it is a 4 speed thanks for all your help mark
|
|
|
|
05-09-2010, 07:55 PM
|
#2 | |
|
Junior Member
Join Date: Dec 2006
Location: Southeast Missouri
Posts: 2,436
|
Re: shout out for help
Quote:
Danny
__________________
'67 Chevy C-20 short stepper - build complete, 454/SM-465. '75 C-30 Single Cab DRW-350 small block/NP-435. '77 GMC-6500 Dump Truck, 427 Tall Deck. '92 GMC K-3500 Duallie, 454/4L80E. |
|
|
|
|
|
05-09-2010, 07:58 PM
|
#3 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: shout out for help
Yes, the larger hubs had the "bolt-on" style lock-out hubs (or drive flanges). The '73-'87 could have either style.
The value is very regional, I couldn't tell you.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
05-09-2010, 08:00 PM
|
#4 |
|
What?
Join Date: Jun 2007
Location: Southern California
Posts: 7,617
|
Re: shout out for help
Is the frame a rolling chassis?
If it is, and there was a guarantee that it isn't bent. Then the asking price, to me anyways sounds good. Axles alone would take up most of that price.
__________________
Chris 1968 K20 Suburban 1972 K10 LWB PU |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
