Motor mount help

[ratfink13]

Hello,
My name is charles.i am workin on a 67 gmc stepside.now i know why you are all here,this thing is fun!anyways it seems someone has pulled a jethro move on my frame to motor mount brackets.someone threw out the stock brackets and got creative with a welder.I knew the only place to look would be here since this is where the c10 guru's reside.can somebody help me out with a set of stock brackets.i shure could use the help.thank you

[michael bustamante]

you running an inline 6 or a small block? manual or auto tranny? I have a set in inline 6 mounts if you need them, pm me if you do

[ratfink13]

Im tryin to drop in a 350 4 bolt and 350 auto trans.

[BIG ORANGE]

Welcome to the board ratfink13, go ahead read over the forum rules and drop the owner of the board a small fee and become a member of the neatest classic truck forum around, after you have joined then venture over to the 67/72 parts board and place you a WTB thread and tell the guys what you need. V8 sbc or bbc or 6cly engine towers!
happy motoring!!
Big O.

[michael bustamante]

Originally Posted by ratfink13

Im tryin to drop in a 350 4 bolt and 350 auto trans.

the best way to go then is to get sbc motor mount towers and mount them in the foward two mount hole locations on the frame.

[ratfink13]

Do you have a pair for sale?

[michael bustamante]

no I only have inline 6 which would work if you were running a manual trans with no hei

[67/72junkie]

when I install sb for hotrod or performance I use 6 cyl frame stands.swap them from side to side turned backwards in rear frame holes. sb motor mounts. autotrans cross member bolts into factory 6cyl with pwr glide holes and 6 cyl auto trans linkage "longer linkage rod" you can weld ext on sb rod. also uses 56 1/4" 6cyl drive shaft.motor will set back 7" from factory sb position.can also use hei distributor cap .it will clear firewall by 1/4" as long as your cab mounts are not worn out.truck will launch better and ride and handle much better than factory sb position.