|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-30-2010, 09:45 PM
|
#1 |
|
Registered User
Join Date: Sep 2007
Location: Gray,Tennessee
Posts: 182
|
Serpentine belt question
I am installing a 402 from a '71 Chevelle in my '83 GMC. I bought a '93 model 454 from a Suburban that I was going to use but thought the 402 would be cooler to talk about. But anyway..
Can I use the serpentine belt setup from the '93 motor on the 402? Has anyone done this before. Pics would be great Thanks for any intel or advise. 
__________________
'85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD |
|
|
|
05-31-2010, 01:02 AM
|
#2 |
|
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Re: Serpentine belt question
It should bolt right up.
|
|
|
|
|
05-31-2010, 04:43 AM
|
#3 |
|
Registered User
Join Date: Sep 2007
Location: Gray,Tennessee
Posts: 182
|
Re: Serpentine belt question
thanks, can i run a normal long water pump or must i get one that runs backwards?
__________________
'85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD |
|
|
|
|
05-31-2010, 06:14 AM
|
#4 |
|
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Re: Serpentine belt question
If you use a serpentine setup, you need a reverse rotation pump.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
