How to set up pinion angle with 2 piece drive shaft

[m6z]

Originally Posted by porterbuilt

You will need to set it up at ride height, and have the engine/trans, carrier bearing, and rear-end mocked up to get the proper angles figured out. Shoot me a call tomorrow, and I will help you get it dialed in! 480-326-6303

Could you or anyone for that matter explain this in a write up? I haven't been able to find this info any where online.

[PBFAB.COM]

Originally Posted by m6z

Could you or anyone for that matter explain this in a write up? I haven't been able to find this info any where online.

What system are you running?

[m6z]

Originally Posted by porterbuilt

What system are you running?

I picked up a complete SD rolling chassis(deal was to good to pass up). So I'm running their front crossmember and rear wishbone super lift kit. I would think it would be the same as someone running your setup or anyone trying to set up a air ride system at ride height with the 2pc shaft.