|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-17-2010, 02:01 PM
|
#1 |
|
Registered User
Join Date: May 2009
Location: Hazel Green AL
Posts: 286
|
Steps of putting door shell back together after paint
I have been looking at the FAQ's for the last hour and i printed off some good info i still am not sure on which compontents goes first.Is this correct?Tape up to keep from scratching paint,Put vent windows in first,door lock/ latch mechanism,inner and outer fussies,regulator and glass.Is this the right order?
|
|
|
|
07-17-2010, 07:29 PM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: Steps of putting door shell back together after paint
Personally I would put the regulators in first. Mainly because they are going to take the most fiddling to re-install. Also because they don't have to come out for painting in the first place, of course with new doors, they were never there. Everything else can come out (or go back in) with the regulators in place.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
07-18-2010, 09:22 AM
|
#3 |
|
Registered User
Join Date: May 2009
Location: Hazel Green AL
Posts: 286
|
Re: Steps of putting door shell back together after paint
Thank you Longhair for the info.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
