|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-08-2003, 08:13 PM
|
#1 |
|
Registered User
Join Date: Jul 2002
Location: pottsboro,tx
Posts: 513
|
?'s about ign bezel and dash pad
today i took off my old dash pad,without too much trouble and wondered if a new one is any harder to put on?...do most of them come with new hardware or do i need to save mine?...my other question has to do with the ign bezel....how the hell do you get it off?....i thought it unscrewed,but mine wont....it turns,but its not unscrewing....so now its all chewed up and im gonna have to buy a new one....anybody tell me how to get that off?
|
|
|
|
06-08-2003, 08:21 PM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: hughesville, pa usa
Posts: 337
|
Yes, usally when you buy a new pad, they give you the nuts with it. As for the ign. benzel, there is a small hole next to the key insert. Get a small but firm wire and insert. I think there is a small spring in there when you turn it, it should pop off in the back and slide out. I had the same problem with mine a few years ago but played with it and managed to get it off.
__________________
Dave Benamati Hughesville, PA USA |
|
|
|
|
06-08-2003, 11:22 PM
|
#3 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
To add to dbenamati's explination...you turn it counter clock wise with the key in ti with the wire in the hole.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
