|
11-01-2010, 01:40 PM
|
#1 |
|
Registered User
Join Date: Jun 2009
Location: Bowie, Maryland
Posts: 37
|
valve cover gasket?
i am replacing my valve cover gaskets but the problem is the old ones are stuck on the valve cover pretty good. i have gotten some of it off with a screw driver but i was wondering if there is a better way to do it?
__________________
-dd: 1971 c10 307/3ott 3/5 drop -future project: 1967 chevelle convertible 283/4spd |
|
|
|
11-01-2010, 01:59 PM
|
#2 |
|
U.S. Army Green Beret Sniper
 
Join Date: Dec 2009
Location: Enterprise Alabama
Posts: 57
|
Re: valve cover gasket?
I would use toluene or MEK either one of these items will soften the gasket where you could remove it. They also make products for gasket removal aids.
__________________
 "YOU CAN RUN AND YOU CAN HIDE, BUT YOU WILL JUST DIE TIRED"
|
|
|
|
|
11-01-2010, 02:54 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: valve cover gasket?
a gasket scraper is a tool made for the job
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
11-01-2010, 03:39 PM
|
#4 |
|
Account Suspended
Join Date: Jun 2000
Location: over yonder
Posts: 14,270
|
Re: valve cover gasket?
get off as much as you can by scrapping then use a brass wire brush in a drill ...
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
