|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-17-2003, 10:39 PM
|
#1 |
|
Registered User
Join Date: Mar 2002
Location: Bondurant, IA but in Worcester, MA for school
Posts: 767
|
Snapped U-bolt Today???
Anyone know what the u-bolt torque specs for a 70 C20 with leafs is? I think I over torqued the new ones I put on when I pulled some leafs because I snaped one right in half today. These were some universal ones that I got at the local auto store. They were not as thick as the ones I pulled off and they did have about 1/8th to 1/4 of an inch of slop between the leafs and the bolt on ether side. I think I am gonna just go get a set of new originals and put those on but until i get them ordered any help would be apreceated. Thanks
HotRod
__________________
1970 Chevy C-20 350 V-8 Turbo 350 w/ shift kit Dana 60 w/ 4.10 gears AND Powr-Loc POSI New Additions: Summit Headers 135amp alternator Proform HEI Edelbrock 1406 600cfm carb Sunpro Tach Powr-Loc POSI Edelbrock Performer RPM Intake MSD 6A Ignition Box AIM: HotRod929 Visit My Site: http://1970chevy.netfirms.com/ |
|
|
|
06-17-2003, 11:04 PM
|
#2 |
|
Registered User
Join Date: Mar 2003
Location: Stillwater MN
Posts: 1,166
|
Hotrod, if you can snap a u-bolt with a hand wrench...they are junk!!! Factory spec is 150 ft. lbs.
__________________
69 GMC K10 ..some restoration required....still.. 
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
