|
11-19-2010, 01:52 AM
|
#1 |
|
Registered User
Join Date: May 2006
Location: So.Cal
Posts: 542
|
Window felt install?
Anybody have a tip or trick to install window felt on a 1970 chevy c-10?
|
|
|
|
11-19-2010, 02:26 AM
|
#2 |
|
Registered User
Join Date: Nov 2009
Location: Austin Tx
Posts: 639
|
Re: Window felt install?
I bent the center tabs out just a little bit on all of them, got the felt to were almost all the tabs were lined up with the holes and just started popping them in. I just did both doors other day along with all new vent window seals and channel felts- it all went way to easy... I was really worried from what I had read that it was a tough job.
|
|
|
|
|
11-19-2010, 06:24 AM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Window felt install?
What works for me is to get someone to help install them. One person on each side of the door. For example, when installing the outer fuzzie, the person on the outside does the installing while the person on the inside makes sure of the alignment of the clips. A flashlight makes it easier to see that the clips are starting into the holes. If you miss a hole, that is when trouble starts!
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
11-21-2010, 03:36 PM
|
#4 |
|
Registered User
Join Date: May 2006
Location: So.Cal
Posts: 542
|
Re: Window felt install?
I will try to figure something out.
thanks |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
