|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-13-2010, 03:12 PM
|
#1 |
|
Registered User
 
Join Date: Mar 2002
Location: Dallas, TX
Posts: 555
|
68 3/4 4x4 Rear spring hanger, same as 2x4
I believe 67 and 68 are the same and the hanger changed in 69. Need a new one for the rebuild and would like to know if the hanger is the same on 4x4 and 2x4? The picture shows the good side.
Erl
__________________
1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX |
|
|
|
12-14-2010, 03:53 PM
|
#2 |
|
Registered User
Join Date: Mar 2002
Location: Dallas, TX
Posts: 555
|
Re: 68 3/4 4x4 Rear spring hanger, same as 2x4
No one knows the answer? This is the rear, rear hanger.
Erl
__________________
1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX |
|
|
|
|
12-14-2010, 04:40 PM
|
#3 |
|
Registered User
Join Date: Nov 2006
Location: The Republic of Texas
Posts: 361
|
Re: 68 3/4 4x4 Rear spring hanger, same as 2x4
You're right that 67 and 68 springs and hangers are differnt than later years. Not sure about the 2wd version swapping. I found a 3/4 ton 2wd parts truck, but was coil springs. If I find out, I'll let you know.
__________________
1962 Chevy K10 factory 4x4 stepside longbed http://67-72chevytrucks.com/vboard/s...d.php?t=494632 1967 Chevy 3/4 ton 4x4 long bed (Henrietta) traded 1968 Chevy 1/2 ton panel wagon, V8 and powerglide http://67-72chevytrucks.com/vboard/s...d.php?t=483345 1978 Ford F250, beater stepside 2008 Jeep Wrangler 4 Door 2010 Chevy 4x4 plain jane work truck |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
