58 apache 31 stepside noob project help!

[OrrieG]

Originally Posted by Spackle100

For getting the rust off, this stuff works wonders. Read the warning label if you use it though, there are some things it doesn't recommend using it on.

The HAMB board (google it) has a whole thread on using CLR. It is amazing for what it does but you do need to be careful and wear full eye, face and probably a good breathing mask, you are dealing with a pretty stout acidic material.

Looking at your photos I hope the bed/cab misalignment is in the body mounts and not the frame from sitting on the ground. Looks like a good builder.

[dcody619]

Here are some pics with the bed off and it seems like the frame might be off a bit on left side above the wheel...any ideas?

Also here is a pic of the engine bay where there isn't much of anything so I need help getting a plan on what to buy to get her running?

[dcody619]

Here's another one from a different angle...

Also in order to get it running I have a friend who will give me his running 283 with tranny or should I rebuild this 235? Will doing the 235 be easier to buy parts for and easier to install than a 283...and I don't have a drive shaft either.