|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-02-2003, 12:44 PM
|
#1 |
|
Registered User
Join Date: Nov 2001
Location: SoCal
Posts: 136
|
Header recommendations....
I'm looking to replace my ram horn exhaust manifolds with headers. I've got a '69 with a SB350, TH350 and a NP205. I should also mention the SB350 is a TBI motor. I want to get some quality headers that will last as well as look good. Main concern is proper fit and clearance. What are you guys running and what would you recommend? Any pics on your set up would be great.
Picture of my current exhaust setup...
__________________
'69 Chevy, 4X4-SB 350 TBI-TH350 Trans-205 Transfer Case-Dana 44 Front-14 Bolt Rear-Front Disc Brakes-Factory A/C-P/S Ken's '69 Page |
|
|
|
07-02-2003, 05:58 PM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,727
|
Heddman. Mine lasted 10 years (uncoated) and if I had welded the collectors instead of trying to bolt they would still work, but I was tired of the leaks. I bought 2 1/2" 'vette rams horns, and wouldn't even THINK about doing the headers again.
 I went from 2 1/4" to aluminized 2 1/2" and Walker Hemi Turbos. It is quiet until you romp on it and has excellent tone. I didn't notice any powerloss, actually seemed to make better low speed torque.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
