|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-12-2011, 08:34 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: Grimsby, Ontario
Posts: 205
|
Left rear quarter panel
Does any one know where I can get a repair panel for behind the left rear quarter and around to below the light? Looks like the PO squashed the corner a bit. I started banging it out but thought if there is a panel available I would be better off.
|
|
|
|
02-13-2011, 10:13 AM
|
#2 |
|
Registered User
Join Date: Apr 2008
Location: Angleton, TX
Posts: 2,219
|
Re: Left rear quarter panel
Your best bet would be GMC Pauls. You might have to get a truck patch and trim it down to fit as a blazer. Good luck!
__________________
I don't always drive trucks; but when I do I prefer Chevy's. Stay driving my friends. '72 blazer 2wd build 67-72 Factory Big Block Registry |
|
|
|
|
02-13-2011, 08:01 PM
|
#3 |
|
Registered User
Join Date: Jan 2010
Location: Grimsby, Ontario
Posts: 205
|
Re: Left rear quarter panel
Thanks I will have to see if they have one.
|
|
|
|
|
02-14-2011, 04:31 PM
|
#4 |
|
Registered User
Join Date: Feb 2003
Location: Santa Ana, CA
Posts: 2,191
|
Re: Left rear quarter panel
I just replaced this exact spot on my Blazer. You have two options. 1 - Buy a complete repop bedside for $$ because they don't just sell the tail light section for our trucks (suburbans yes, trucks and blazers no). 2 - cut the section out of a donor truck bed. That is what I did. Saved major coin, and got a few other patches I needed as well. Just look around in the classifieds and you will find what you are looking for.
|
|
|
|
|
02-14-2011, 05:56 PM
|
#5 |
|
Registered User
Join Date: Jan 2010
Location: Grimsby, Ontario
Posts: 205
|
Re: Left rear quarter panel
Great advice. I have access to a bunch of old pick ups locally I will have to get a donor peice in the spring once out from under the snow...lol. Again thanks for the advice.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
