|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-21-2011, 06:46 AM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Question About Neutral Safety Switch and Van Tilt Column
I use the truck switch and install it on the lower end of the column in the same position as the truck columns. A slot is needed as well as welding in a "tab" that fits into the slotted tange on the truck switch. If you put the switch higher up on the column there are clearance issues.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
| Bookmarks |
| Tags |
| neutral safety switch, tilt, van column |
|
|
Threaded Mode