|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
03-27-2011, 11:49 PM
|
#1 |
|
Registered User
Join Date: Feb 2010
Location: San Diego, CA
Posts: 88
|
Re: What did you do to your truck today!
Channeled my bed 4 inches so i can run my air ride and still have full use of my bed.... Cut a longbed floor down to a shortbed floor because the PO had destroyed my shortbed floor (He used to drag race the truck so he cut half the floor out for a fuel cell and tubbed it)... Then I cut down the tubbed inner fenders to stock + 2 inches....
P.S. Thanks to ka_jd7and1 for the bed floor... much appreciated Last edited by keanevann; 03-27-2011 at 11:51 PM. Reason: added |
|
|
03-28-2011, 12:17 AM
|
#2 |
|
Registered User
Join Date: Nov 2010
Location: Grand Terrace, Ca.
Posts: 1,607
|
Re: What did you do to your truck today!
Yesterday I posted that my new $750 Hooker headers wouldn't fit. After more investigation and trimming of the driver's side lower control arm (drum roll) they fit (almost). Turns out Hooker, in their wisdom, didn't relieve the header flange to clear the head bolt heads that are installed on a ZZ502 crate motor, so, the headers are on my truck but I need to replace 8 head bolts with head bolts that have shorter bolt heads. Anyone heard of this before?
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
