|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-18-2003, 07:50 PM
|
#1 |
|
Registered User
Join Date: Jun 2003
Location: Ponder, TX
Posts: 33
|
Axels to fit leaf spring rear end.
Well finally got around to pulling the leaky cover off of the leaf spring rear end I have so I could get rid of that nasty oil smell. While the cover was off, I decide to go ahead and pull the axels and check the wheel bearings. Both bearings were pitted, and worse, so were both axels
  . I went over to O'Reilly Auto Parts and got the repair bearing kits, cleaned everything up and got everything back together. The new bearings should hold for a few years (truck is not my daily driver), but now I would like to score a set of replacement axels for the future. Anyone know if Blazer axels will fit, or am I stuck looking for another truck? My truck is a 1/2 ton, five lug. May have to go aftermarket, but I'll have a few years to look.
__________________
'67 1/2 Ton Short Bed / 396 cid / AC w-R134a / 5 Lug Leaf spring rear axel / 5 Lug Frt Disk Brake Conversion '97 Trans Am - Black / LT-1 / K&N FIPK Cold Air Kit / Hooker Cat-Back Exhaust / 160 Thermostat '02 Buick Regal GS / Bone Stock |
|
|
|
07-18-2003, 08:12 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
I'm thinking that the 71 to 87 is about the same....but verify that before taking my word for it.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
