![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Apr 2009
Location: Avondale, AZ
Posts: 46
|
Trick to removing clutch z bar?
I've got the rods unhooked, the nut, lockwasher and lock clip removed and can lift it out of the mount on the frame, but I can't pull it off the ball stud on the motor side. I can't lift it high enough to clear the bracket on the frame. Is there a trick to getting it out of there? '66 GMC 3/4 ton with V6 351 E.
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2010
Location: gadsden, alabama
Posts: 468
|
Re: Trick to removing clutch z bar?
slide a jack under the trans and pick it up a bit until it clears the bracket and slide it out
__________________
Due to financial constraints, the light at the end of the tunnel will be shut off until further notice |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Apr 2009
Location: Avondale, AZ
Posts: 46
|
Re: Trick to removing clutch z bar?
That did it! Out in 30 seconds. Thanks bama.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|