|
04-18-2011, 08:19 PM
|
#1 |
|
Registered User
Join Date: May 2010
Location: St.Louis
Posts: 644
|
Hazard lights on
I just replaced my electronic panel behind the dash because the temp gauge wasnt working. Now everything works. But when I flip on my headlights I see the hazard light indicators light up on the panel. However the hazard lights are not on. When i pull the hazard lights out they flash accordingly. So what could cause the arrows show up when I pull the headlights?
I'm lost on this one. |
|
|
|
04-18-2011, 08:30 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Hazard lights on
It could be a ground issue with the circuit or it is possible that the cardboard tubes surrounding the indicators are not sealed and there is light from the dash lights coming into the tubes.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
04-18-2011, 08:38 PM
|
#3 |
|
Registered User
Join Date: May 2010
Location: St.Louis
Posts: 644
|
Re: Hazard lights on
Hmm I will have to check on the cardboard. I never had this issue til I replaced the back panel.
|
|
|
|
|
04-18-2011, 10:46 PM
|
#4 |
|
Registered User
Join Date: Aug 2008
Location: Lethbridge,Alberta
Posts: 532
|
Re: Hazard lights on
My left indicator stayed on when I put my head lights on because my front left signal was burned out. How are your signals in your front bumper. I assume you have a 72.
|
|
|
|
|
04-19-2011, 08:14 AM
|
#5 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
|
Re: Hazard lights on
try grounding the inst panel a little batter. I alwways run a ground wire from the steel back of the panel to the dash
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
