sway bar ?

[texastrendz]

i am installing nate's sway bar kit on my 72 with a dropmember and factory 73-87 a arms. my question is the sway bar is close to the rack and pinion setup, it is about 2 inches from touching at ride height and is this safe? it will fully cycle without touching. just gets close at some points when traveling the full cycle.

[PBFAB.COM]

Originally Posted by texastrendz

i am installing nate's sway bar kit on my 72 with a dropmember and factory 73-87 a arms. my question is the sway bar is close to the rack and pinion setup, it is about 2 inches from touching at ride height and is this safe? it will fully cycle without touching. just gets close at some points when traveling the full cycle.

Yes it is safe... and when you get the other tabs I am making for your factory arms it will give you a little more room. The little angle ones you have in the pics set the bar a little higher.

[texastrendz]

hey nathan thanks for the response. i was expecting the new tabs to be the same dimensions with a porterbuilt twist. i will hold off drilling any hole until i see the new brackets. thanks again, Daniel.