|
04-21-2011, 09:30 PM
|
#1 |
|
Registered User
Join Date: Jul 2009
Location: Clearviller PA
Posts: 50
|
pinion angles
The truck 82 half ton dropped 6 in the front and 6 in the back
I'm having u-joint problems obviously' but what i was wondering what angles do the pinions have to be, or what shims to order, is what i need to find out. The truck has a two piece drive line so the carrier bearing and the rear needs shimmed, i heard that 2 degrees within the carrier and trans is what i was told just wondering what everyone els did with the shims. |
|
|
|
04-22-2011, 05:29 PM
|
#2 |
|
Registered User
Join Date: Feb 2010
Location: mesa az
Posts: 211
|
Re: pinion angles
I had the same problem, mine is a coil set up. The rearend shop said i should go 6 degrees. Good luck
|
|
|
|
|
04-23-2011, 01:35 AM
|
#3 |
|
At the body shop.
Join Date: Aug 2009
Location: Land of fruits and nuts.
Posts: 5,200
|
Re: pinion angles
 hope this helps if the trans is down 3 degrees the rearend needs to be up 3 degrees. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
