|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-28-2011, 07:52 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: Forsyth, Ga
Posts: 1,012
|
Pic request: Rack and Pinion Notch for Dropmember
I am laying this out and the instructions I have there is an oblong hole that remains after installation in the pic. The pic I believe is from a newer frame. On my frame an oblong hole is at the 2.5 inch down mark and will be completely removed if what I did was correct. So before i cut this out does anyone have some good pics I could use as a reference?
I appreciate it. |
|
|
|
04-28-2011, 10:59 PM
|
#2 |
|
Needs a Big Block
Join Date: Oct 2003
Location: Red Deer , Alberta
Posts: 1,198
|
Re: Pic request: Rack and Pinion Notch for Dropmember
Hey dude, Im not able to get any pics but I put I'n my rack notches a couple of weeks ago , on my 64 the oblong hole gets cut out, you are correct.
Posted via Mobile Device
__________________
1964 Short box On dropmembers and billets 1962 Suburban family cruiser 1972 K10 |
|
|
|
|
04-29-2011, 01:42 AM
|
#3 | |
|
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: Pic request: Rack and Pinion Notch for Dropmember
Quote:
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
