|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-01-2011, 10:52 AM
|
#1 |
|
Registered User
Join Date: Apr 2010
Location: Boise, ID
Posts: 1,280
|
One more PS question - help please!
On the pic below with my power steering gear there are grooves then a gap and then more groves. Are the grooves closest to the steering gear for the rag joint and the outer grooves for sliding into the steering column shaft?
Last edited by ubtripn; 05-01-2011 at 12:41 PM. |
|
|
|
05-01-2011, 12:02 PM
|
#2 | |
|
Registered User
Join Date: Mar 2010
Location: Pueblo West, CO
Posts: 944
|
Re: One more PS question - help please!
Quote:
__________________
67 C10 Stepside 66 Mustang Coupe 99 Burb 2500 |
|
|
|
|
|
05-01-2011, 12:41 PM
|
#3 |
|
Registered User
Join Date: Apr 2010
Location: Boise, ID
Posts: 1,280
|
Re: One more PS question - help please!
My mistake, here ya go. thx
|
|
|
|
|
05-01-2011, 01:19 PM
|
#4 |
|
PROJECT 7DEUCE
 
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,608
|
Re: One more PS question - help please!
The whole rag joint assembly will slide on to the splines and then the steering column shaft will bolt to the rag joint assembly. Hope this helps ya..
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
|
05-01-2011, 01:28 PM
|
#5 |
|
Registered User
Join Date: Apr 2010
Location: Boise, ID
Posts: 1,280
|
Re: One more PS question - help please!
it does, thanks a ton! I thought for sure the shaft would go into the other. No wonder a good rag joint is so important for safety.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
