|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-02-2011, 05:09 PM
|
#1 |
|
Registered User
Join Date: Apr 2011
Location: Smithfield NC
Posts: 19
|
Need some help with engine #s please
I just bought this 86 truck and to make a long story short got hosed.
I found 2 sets of numbers on the engine. This one is located right behind the alternator in front of the head K0923FKB Best I have figured out from searches is K= Ontario 09= Sept. 23= 23rd FKB= ?????? The other number I found below the head on passenger side where the motor mount bolts to the block A0910 but don't know what any of that means. This motor is in an 86 and the way I figured out it's not supposed to be there is there is no fuel pump block off. The truck is supposed to be 305 according to the VIN. Thanks for any help Duke
__________________
1986 2wd 305 longbed WTF have I done 
|
|
|
|
05-02-2011, 05:29 PM
|
#2 | |
|
Registered User
Join Date: Oct 2003
Location: OC CA
Posts: 1,374
|
Re: Need some help with engine #s please
Quote:
If the oil dipstick is on the passenger side then it is likely to be: FKB 1994 305 Truck 175HP L-03 TBI Locate a block casting number on driver side bellhosing - just behind the head. You should see 5.0L and a casting number - for example (1988-94) 14093627 or 14094766. //RF
__________________
"The Beast" 1975 Chevrolet C20 longbed 350/700R4! with 3inch body lift Dual Flowmasters Super 40's! TBI retrofit completed (2007-07-29)  New 383CID (+030) 08-304-8 9.5:1CR x36,005 (2012-12-17) |
|
|
|
|
|
05-02-2011, 08:42 PM
|
#3 |
|
Registered User
Join Date: Apr 2011
Location: Smithfield NC
Posts: 19
|
Re: Need some help with engine #s please
Yep that's what it is. I don't understand someone going to the trouble of changing out the motor and not putting a 350 in it. Also it looks like a stock intake but a 94 is TBI would the 86 intake have fit this 94 motor so they could use the Holley carb.?
Later Duke
__________________
1986 2wd 305 longbed WTF have I done
|
|
|
|
|
05-02-2011, 09:53 PM
|
#4 |
|
78K & 79C Jimmys
Join Date: Nov 2009
Location: Ottawa Ont CANADA
Posts: 7,901
|
Re: Need some help with engine #s please
$$
if you had to send a core block back, it had to be the same as you got i know a guy who was recently shocked after pulling a 350,and it's not a 350 but some would put a 305 back in if they couldn't afford the core charge
__________________
John 1978 GMCJimmy4X4-350/203 1979 GMCJimmy4X2-305/350 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
