71 c10 Newer Engine install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

angelsairman · 07-23-2003, 10:51 PM

i have a 1971 C10 1/2 ton 2WD that i pulled the 307 out of. I built a early 80's 350 for it. I noticed in the Factory Assembly Manual that there is a set of rear mounts. The block i have has no mounting holes for these. Is this going to be a problem or will it be good with just the front mounts or am i way off????...

krue · 07-23-2003, 10:56 PM

Welcome to the board from South Mississippi!
As far as I know all the small blocks bolt in the same. You can take the mounts off your current small block and put them on your 350 and throw it in there. You can mount it in the inline six position which sets it further back if you want.

07-23-2003, 10:51 PM	#1
angelsairman Future Owner Join Date: Jul 2003 Location: Grand Forks AFB, ND Posts: 151	71 c10 Newer Engine install i have a 1971 C10 1/2 ton 2WD that i pulled the 307 out of. I built a early 80's 350 for it. I noticed in the Factory Assembly Manual that there is a set of rear mounts. The block i have has no mounting holes for these. Is this going to be a problem or will it be good with just the front mounts or am i way off????...

07-23-2003, 10:56 PM	#2
krue Designated A-hole! Join Date: Mar 2003 Location: South Mississippi Posts: 36,448	Welcome to the board from South Mississippi! As far as I know all the small blocks bolt in the same. You can take the mounts off your current small block and put them on your 350 and throw it in there. You can mount it in the inline six position which sets it further back if you want. __________________ "If it ain't broke, fix it 'til it is!" Being stupid ain't illegal. We're Still Debt Free Except for the House!!! www.daveramsey.com 70 GMC SWB Stepside project "Green Booger" soon to be 6.0l/4l80e 93 S-10 "Poppaw's Truck"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.