Project: Ginger

[69CST-V]

Great work. Looking nice and clean.

[lolife99]

Originally Posted by theCheyenneShop

Just getting a first look at your "Ginger" and she is hot, smoking HOT! Can't wait to see how she lays

Originally Posted by 69CST-V

Great work. Looking nice and clean.

Thanks guys.
I can't wait to see it on the ground and done.
(at least driveable)

I got home late tonight and found the UPS truck had been here.
I got my "sandlewood" dash pad from Brothers Truck Parts.
This is one of the "Made in the U.S.A." dash pads.
The quality is definitely better than the other aftermarket dash pads I have had,... but there were a few "finished" areas on the upper and lower edges that I didn't like too much.
Not terrible,... but just sloppy.
(I guess these are the areas of the dash pad, that are trimmed off after they come out of the mold?)

I'm being too picky,... so I just went ahead and installed it.
I gotta keep plowing forward,...

[litew8]

I think I can see the "lower" part you don't like. Above the cluster and near the radio? If it were me, I'd send it back and get a replacement.

[lolife99]

Originally Posted by litew8

I think I can see the "lower" part you don't like. Above the cluster and near the radio? If it were me, I'd send it back and get a replacement.

I think what you are seeing,... is the recessed holes for the lower screws.
I may call Brothers and ask them about it.
I'm sure they have no answers.
They just sell them.
I doubt that they manufacture them.

[hot trux]

LOOKIN GOOD MAN!!!

[n2billet]

Originally Posted by hot trux

LOOKIN GOOD MAN!!!

I agree....