|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-24-2011, 02:49 AM
|
#1 |
|
English Chevy Owner
Join Date: May 2002
Location: Shropshire, UK/ Lot, France
Posts: 1,848
|
More bolt sizes and water pump question
This time timing chain/Cam cover, I took my water pump off yesterday to clean it up and paint it and found a couple of missing bolts in the timing chain/cam cover, what size are they? I'm guessing its 1/4"-20 but I'm probably wide of the mark. Is there any document anywhere that lists all the different bolts used in a SBC to save me bothering you lot all the time?
Secondly, should the nose of the waterpump where the shaft comes out be packed with grease or was it just the accumulated crud of ages? If so do I need proper waterpump grease? As always, thanks guys.
__________________
Phil '67 C10 long fleet. 350/TH350, 4 bbl Carter, K&N, Dual exhaust, loads of stuff coming soon 2001 S10 Blazer Daily Driver, bone stock 4 door 4x4 with manual transmission |
|
|
|
07-24-2011, 02:55 AM
|
#2 |
|
Registered User
 
Join Date: Jul 2010
Location: memphis
Posts: 2,537
|
Re: More bolt sizes and water pump question
you are right on tha bolt size & that is jus crud, you don't have to use grease on tha water pump.
__________________
1981 C-10 (Pop's) 1978 Camaro 2006 Lacrosse |
|
|
|
|
07-24-2011, 03:02 AM
|
#3 |
|
Master Procrastinator
Join Date: Sep 2009
Location: Grande Prairie AB Canada
Posts: 1,128
|
Re: More bolt sizes and water pump question
pick up an arp accessory bolt kit, I got a stainless bolt kit shipped to northern canada for under $100 and the black ones are a bit cheaper. The kit has everything for the whole motor externally and comes all sperately labeled
__________________
 My Buildhttp://67-72chevytrucks.com/vboard/s...d.php?t=39550620 Duramax tow pig 68 2wd short stepper project 77 2wd short fleet beater 52 short project |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
