|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-04-2010, 09:27 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
|
installing dropmember notches
just wanted to share how i squared the rack notches for the porterbuilt drop member. i layed them out on a flat square surface and clamped them to a piece of angle iron. then i tacked them to the angle iron so they would stay true to each other. then i clamped them into the notch slots per porterbuilts instructions.
  
|
|
|
|
04-04-2010, 10:20 PM
|
#2 |
|
Registered User
 
Join Date: Dec 2008
Location: Mt. Pleasant, TX
Posts: 268
|
Re: installing dropmember notches
wish i would have thought of that
|
|
|
|
|
04-04-2010, 11:47 PM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,071
|
Re: installing dropmember notches
That's how I did mine. Angle steel clamped to the tops & sides w/a level in the center to ensure they're square to the frame. Did my rear c-notches the same way too....
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
04-05-2010, 02:36 AM
|
#4 |
|
Registered User
Join Date: Jan 2007
Location: Denton, Texas
Posts: 356
|
Re: installing dropmember notches
Yep, that's how I did my c-notches as well. Works great.
__________________
Andrew '69 C-20(292, 4-speed) Retired Daily Driver '64 C-10(250, 3-speed) Fixerupper '97 F*rd Mustang GT(4.6L, 5-speed) Daily Driver If I only wanted two pedals I'd have bought a bicycle.
 |
|
|
|
|
04-13-2010, 05:48 PM
|
#5 |
|
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: installing dropmember notches
bump
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
|
|
|
|
07-31-2011, 09:42 PM
|
#6 |
|
Registered User
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
|
Re: installing dropmember notches
ttt for the future dropmember installers
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
