New lines Fuel and hard Brake lines for my stepside

[Navy_chief]

Guys,
I need to find new fuel lines for my 1977 GMC 4x4 K15 stepside truck with the 16 gal fuel tanks from the tanks to the fuel pump and new hard brake lines as well any sources for these?
Thanks Matt

[juiceman650]

Have you checked LMC?
Posted via Mobile Device

[hatzie]

The guys below sell pre-bent lines and sets of lines. I've seen both companies products in use and they are beautifully made. I usually bend and flare my own because I can't justify the $ cause I have the high $ tooling.

Inline Tube

Classic Tube

[maskale]

I went to autozone and picked up a roll of polyarmour and fittings and got there loaner tool. I havent actually got around to making them yet though.

[88Jimmy4x4]

I bought new trans cooler lines from LMC and they look very nice, I was very pleased with the quality. I plan on buying more lines from them as well.

[chrismoore701]

I bought straight lines, and used the old ones for a template and got it right on the first try. not that hard, just be patient and check and double check your bends. I bet you can do it this way for less than 25% of the cost of pre-bent lines

[motornut]

except for some weird/short brake line
i always buy the rolls for gas and tranny
have my own flare kit,and bend it around what ever works
too costly the prebent lines and if your lifting or lowering the prebents may not work for you

[pwtr02ss]

I just bought the LMC front kit because I couldn't find the coil bent lines that come off the master cylinder anywhere. I think thats what they are called. Anyway they leaked like crazy and I ended up cutting the flare off and redoing them myself. Pretty aggravating to spend over $150 for brake lines then they leak like that

[S10Fan]

I recently made all new lines for my 50 Chevy sitting on an S-10 chassis. Anyway, borrowed a Snap-On hydraulic flaring tool from a friend, that thing should have it's own national holiday! Awesome tool.

[motornut]

Originally Posted by pwtr02ss

I just bought the LMC front kit because I couldn't find the coil bent lines that come off the master cylinder anywhere. I think thats what they are called. Anyway they leaked like crazy and I ended up cutting the flare off and redoing them myself. Pretty aggravating to spend over $150 for brake lines then they leak like that

those master coils .....just wrap the pipe around a can of beans or something about that size
they are for stress and flex so no harm if not the same size around as before

[pwtr02ss]

Originally Posted by motornut

those master coils .....just wrap the pipe around a can of beans or something about that size
they are for stress and flex so no harm if not the same size around as before

I just wanted it to look clean a factory new. Next time I will def build my own